Other Maintenance
6. Close the Ink T ank Cover .
At this point, ink is drawn out from inside the tubes.
Important
• Do not remove the Maintenance Cartridge during this process.
When the process is nished, Completed! T urn Power Off!! is displayed.
Pack the printer
1. Press the Power button and turn of f the printer .
Important
• T urn of f the printer before you unplug it. It may damage the printer if you unplug it before it is of f
and transfer it in that state. If you accidentally unplug the printer , plug it in again, reinstall the ink
tanks, and follow this procedure again.
2. Disconnect the power cord and interface cable.
3. T ape down printer covers to secure them, in the reverse order of tape removal during installation.
4. Remove the Stand by reversing the installation procedure, when it was attached to the printer .
5. Disassemble and repackage the Stand by following the installation procedure in reverse.
6. Repack the Roll Holder , Holder Stopper , and printer in shipping materials, and then package
them in a shipping box.
Maintenance 653