Ink T anks
Checking Ink T ank Levels
On the Display Screen , you can check how much ink is left in the ink tanks.
T o check remaining Ink T ank levels, access the T ab Selection screen on the Control Panel and press ◄ or
► to select the Ink tab ( ).
Note
• If the T ab Selection screen is not displayed, press the Menu button.
• If an error has occurred and the T ab Selection screen cannot be displayed, display Ink Info as follows.
1. Press the OK button to display Printer Info .
2. Press the ▲ or ▼ button to select Ink Info .
3. Press the OK button.
The remaining ink levels shown on the Display Screen correspond to the inks identied by the Color Label on
the bottom of the Display Screen .
These symbols may be displayed above the ink level: “!” if ink is low , “×” if no ink is left, and “?” if you have
deactivated ink level detection.
The remaining ink level is indicated as shown below .
If the Display Screen indicates to replace the Ink T ank , replace the Ink T ank . If a message is displayed
indicating to check the remaining ink levels, or after tasks that consume a lot of ink such as large-format
printing or head cleaning, check the remaining levels and replace Ink T ank as needed. ( → P .623 )
628 Maintenance