1- 25
îš‹ Function Menus
TOP
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
NetWare Sets the network interface for NetWare
protocol. After configuring all of the settings,
select Store Setting to save the settings and
enable them. This menu is displayed only when
the network interface is installed. (→ P. 5- 3 5 )
NetWare Off*, On Determines whether the NetWare protocol is
used.
Frame Type Auto Detect, Ethernet 2, Ethernet
802.2*, Ethernet 802.3, Ethernet SNAP
Selects the frame type to use.
Print Service BindaryPserver, RPrinter,
NDSPserver*, Nprinter
Selects the print service.
AppleTalk On, Off* Determines whether AppleTalk protocol is
used. After configuring all of the settings, select
Store Setting to save the settings and enable
them. This menu is displayed only when the
network interface is installed. (→ P.5-30)
Ethernet Driver
Sets the method of communication for the network
interface board. After configuring all of the settings,
select
Store Setting
to save the settings and enable
them. This menu is displayed only when the network
interface is installed. (
→
P. 5 -6
)
Auto Detect On*, Off Sets the network card to automatically detect
the LAN communication protocol. If set to OFF,
the communication method and Ethernet type
setting values are enabled.
Comm. Mode Half Duplex*, Full Duplex Selects the LAN communication method.
Ethernet Type 10 Base-T*, 100 Base-TX Selects the LAN communication method.
Spanning Tree Not Use*, Use
This selection determines whether the LAN spanning
tree packets are received and supported.
MAC Address Displays the MAC address of the network
interface board.
Store Setting Ok?
Init. Settings Ok? Resets all of the Interface Setup settings to
their factory defaults.
Maintenance
Menu Item Setting Values Function
To Next Page
Loading...
Need help?
General