1- 26
îš‹ Function Menus
TOP
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
Replace P.head No, Yes Performs the processing required for printhead
replacement. This menu is not displayed if the
maintenance cartridge capacity warning is
displayed. (→ P. 4- 2 1 )
Move Printer No, Yes
Performs the processing required before
transporting the printer to another location. This
menu is not displayed if the maintenance cartridge
capacity warning is displayed. (
→
P.4-33
)
System Setup
Warning
Buzzer On*, Off Sets the buzzer function. When set to On, the
buzzer sounds when an error occurs.
Head Ht. Wrning ON*, OFF, Check Head Hght Determines whether a prompt is issued when
the printhead is not at the correct height for the
print media.
Med.type Wrning On*, Off Determines whether a warning is issued when
the media loaded in the printer does not match
the media specified for the print job.
Change Cutter No, Yes Prepares the printer so the cutter can be
replaced when replacement is necessary. After
replacement, you can reset the number of cuts.
Keep Media Size Off*, On When set to On, printing is performed
according to the specified paper size. The
image may extend beyond the top, bottom,
right, and left edges.
Important
z If set to Off, the image will be printed cleanly,
leaving the recommended 5-mm border at the
top, bottom, right, and left edges. However, a
long sheet with ample top, bottom margins
should be used.
Menu Item Setting Values Function
To Next Page
Loading...
Need help?
General