5- 13
îš‹ TCP/IP Network Settings (Windows, Macintosh, UNIX)
トップ
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
TOP
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
5 Press the [] or [] buttons to select IP
Address, and then press the [
] button.
6 Press the [] or [] buttons to select the
number within the IP address to change, and
then press OK button.
7 Press [] or [] to change the number to
the IP address assigned to the printer, then
press [
] or OK button.
Each time you press the [] button the number
increases by 1. The next number after 255 is 0.
Each time you press the [] button the number
decreases by 1. The next number after 0 is 255.
Note
z If you press and hold the [] or [] button, the value
increases or decreases in steps of 10.
8 Repeat Step 6 to 7 to enter the IP address
assigned to the printer.
Enter the subnet mask.
9 Press the [] button once, and then press
the [
] or [] buttons to select Subnet
Mask, and then press the [
] button.
10Press [] or [] to select the number within
the subnet mask to change, then press OK
button.
11Press [] or [] to change the value of the
number to the subnet mask for the network
you are using, then press OK button.
Each time you press the [] button the number
increases by 1. The next number after 255 is 0.
Each time you press the [] button the number
decreases by 1. The next number after 0 is 255.
12Repeat Step 10 to 11 to enter the subnet
mask that the network is using.
Enter the default gateway.
IP Setting
IP Address ↓
IP Address
=0.0.0.0
IP Address
=XXX.0.0.0
IP Address
=XXX.XXX.XXX.XXX
IP Setting
Subnet Mask ↓
Subnet Mask
=0.0.0.0
Subnet Mask
=XXX.0.0.0
Subnet Mask
=255.255.255.0
To Next Page
Loading...
Need help?
General