5- 33
îš‹ NetWare Settings (Windows)
トップ
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Index
TOP
Contents
Chapter 2
Using Various Media
Chapter 1
Basic Use
NetWare Settings (Windows)
The chapter describes the configuration procedures for
using a printer connected to a NetWare network.
Procedures Required for a NetWare
Network
The following is a summary of the procedures required to
setup the printer for use on a NetWare network.
The following procedure should be performed by the
network system administrator.
1 Installing the network interface board
→ Quick Start
Guide
First, install the optional network interface board.
2 Connecting the LAN Cable → P.5 - 5
Connect the LAN port of the printer to the hub using a
network cable.
3 Setting the Printer Frame Type → P. 5 -3 4
Set the printer frame type. Use the following software
to configure the printer so that it can communicate
with the computer you are using.
• GARO Device Setup Utility (Canon software
application provided with the printer.)
• Printer Operation Panel
4 Setting Up a NetWare Print Service → P.5-37
Configure the NetWare print service. You can
configure the settings from a computer using the
following software.
• NWADMIN or PCONSOLE (Novell software
applications provided with NetWare)
5 Setting NetWare Protocol → P.5-40
Setup the printer protocols. Setup the printer
protocols using a web browser on a computer on the
network.
• Web Browser (Remote UI)
6
Configuring the Computer for
NetWare
→ P.5-44
Perform these settings on every computer that will
use the printer.
To Next Page
Loading...
Need help?
General