Canon LBP3200 - For Windows 2000; Installing from the CD-ROM

Installing the CAPT Software
3-16
Setting Up the Printing Environment
3
For Windows 2000
Installing from the CD-ROM
1 Make sure that the power switch is turned OFF.
IMPORTANT
Do not turn ON the printer until Step 8 during installation procedure.
2 Connect the printer to the computer with the USB cable.
3 Turn ON the computer and start up Windows 2000.
4 Log on by a user who has an administrator's permission.
NOTE
Full Control Permission is required for the installation of the printer driver.
5 Put the supplied "User Software for LBP3200" CD-ROM into
the CD-ROM drive.
If the CD-ROM is already set in the drive, take it out and put it into again.
The CD-ROM menu will appear automatically.
NOTE
If the CD-ROM menu does not appear automatically, select [Run] under the [Start]
menu, enter "D:\English\CAP4MNU.exe", and click [OK]. (The CD-ROM drive
name is indicated as "D:" in this manual. The CD-ROM drive name may differ
depending on the computer being used.)