[Use SNMPv1]
Select the check box to enable SNMPv1. You can specify the rest of SNMPv1 settings only when this check box
is selected.
[Use Community Name 1]/[Use Community Name 2]
Select the check box to specify a community name. If you do not need to specify a community name, clear
the check box.
[Community Name 1]/[Community Name 2]
Enter up to 32 alphanumeric characters for the name of the community.
[MIB Access Permission]
For each community, select [Read/Write] or [Read Only] for the access privileges to MIB objects.
[Read/Write]
Permits both viewing and changing the values of MIB objects.
[Read Only] Permits only viewing the values of MIB objects.
[Dedicated Community]
Dedicated Community is a preset community, intended exclusively for administrators using Canon software,
such as imageWARE Enterprise Management Console. Select [Off], [Read/Write], or [Read Only] for the access
privileges to MIB objects.
[Off]
Does not use Dedicated Community.
[Read/Write] Permits both viewing and changing the values of MIB objects by using Dedicated
Community.
[Read Only] Permits only viewing the values of MIB objects by using Dedicated Community.
6
Specify SNMPv3 settings.
● If you do not need to change SNMPv3 settings, proceed to the next step.
Network
237
To Next Page
Loading...
