Canon LBP710Cx - When an Error Message Appears

When an Error Message Appears
0YSF-06C
If an abnormality occurs in the print processing or the memory is full, or you encounter operation problems, a
message appears on the display. Find out more information about messages in the following list.
Auto Continue
● If you set <Auto Skip Error> to <On> in the setting menu of the operation panel, the printing is continued
with the error skipped regarding the error messages marked with in the list ( Auto Skip
Error(P. 368) ). If the error skip causes missing print data or improper printouts, print the le again.
To cancel printing
● When you want to cancel the current printing regardless of the error message, perform a soft reset. Soft
Reset(P. 498)
About <Show Warnings>
● You can specify settings not to display some messages showing that printing can be continued.
Show
Warnings(P. 369)
18 Drawer N overload. (N=2 to 4)
The paper loaded in the optional paper feeder exceeds the load limit.
● Load paper without exceeding the load limit line.
Loading Paper in the Paper Drawer(P. 40)
1F Output tray is full.
Too much paper is on the output tray.
● Remove the paper from the output tray.
51 Print settings error.
Printing data containing an unavailable paper type or width has been attempted.
● Press ( ) to cancel the print job since the data is not available for printing.
55 SD Card error.
An error has occurred in the SD card.
● Shut down the machine, remove the SD card, and install it again.
Turning ON/OFF the Power(P. 34)
Installing an SD Card(P. 633)
Troubleshooting
519