Canon LBP710Cx - Page 306

[Network] [TCP/IP Settings] [Edit] in [IPP Print Settings] Select the [Use TLS] check box
[OK]
7
Perform a hard reset.
● Click [Device Control], select [Hard Reset], and then click [Execute].
➠
The settings are enabled after the hard reset is performed.
Using the operation panel
● You can also enable or disable TLS encrypted communication from the setting menu of the operation panel.
Remote UI Settings(P. 393)
Starting the Remote UI with TLS
● If you try to start the Remote UI when TLS is enabled, a security alert may be displayed regarding the
security certicate. In this case, check that the correct URL is entered in the address eld, and then proceed
to display the Remote UI screen. Starting Remote UI(P. 336)
LINKS
Generating Key Pairs(P. 320)
Using CA-issued Key Pairs and Digital Certicates(P. 329)
Conguring IPSec Settings(P. 301)
Conguring IEEE 802.1X Authentication(P. 312)
Monitoring and Controlling the Machine with SNMP(P. 235)
Security
300