Canon LBP710Cx - Page 394

( ) <Network> Check the message <TCP/IP
Settings> <Discovery Response> <Off> or <On> Perform a hard reset (
Performing a Hard Reset(P. 498) )
IPSec
Select whether to perform encrypted communication by establishing a virtual private network (VPN) via IPSec.
Use the Remote UI to register and specify the security policies. Conguring IPSec Settings(P. 301)
Off
On
( ) <Network> Check the message <TCP/IP
Settings> <IPSec> <Off> or <On> Perform a hard reset ( Performing a
Hard Reset(P. 498) )
Sleep Notif. Set.
Specify settings for SLP communication to notify imageWARE of the power status of the machine. If you set
<Sleep Mode Notif.> to <On>, you can expect the machine to avoid unnecessary communication during sleep
mode and reduce the total power consumption. Conguring Settings for Device Management
Software(P. 241)
Sleep Mode Notif.
Enable or disable SLP communication. If you select <On>, the power status of the machine is notied to
imageWARE.
Off
On
( ) <Network> Check the message <TCP/IP Settings> <Sleep
Notif. Set.> <Sleep Mode Notif.> <Off> or <On> Perform a hard reset (
Performing a Hard Reset(P. 498) )
Port Number
*
Enter the port number for SLP communications with management software.
1 to 11427 to 65535
Setting Menu List
388