Log on to the Remote UI in Management Mode ( Starting Remote UI(P. 336) ) [Settings/
Registration] [Network] [Dedicated Port Settings] [Edit] Select [Mode 1] in [Authentication
Method] [OK] Perform a hard reset ( Performing a Hard Reset(P. 498) )
● Pressing ( ) cancels the print job.
E001-nnnn (n: Number)
An error has occurred in the xing unit.
● Write down the error code, hold down the power switch for 5 seconds or more to turn OFF the power,
unplug the power plug from the AC outlet, and then contact your local authorized Canon dealer.
Do not turn ON the power
● When this message appears, never turn ON the power after turning it OFF.
E003-nnnn (n: Number)
An error has occurred in the xing unit.
● Write down the error code, hold down the power switch for 5 seconds or more to turn OFF the power,
unplug the power plug from the AC outlet, and then contact your local authorized Canon dealer.
Do not turn ON the power
● When this message appears, never turn ON the power after turning it OFF.
E004-nnnn (n: Number)
An error has occurred in the xing unit.
● Write down the error code, hold down the power switch for 5 seconds or more to turn OFF the power,
unplug the power plug from the AC outlet, and then contact your local authorized Canon dealer.
Do not turn ON the power
● When this message appears, never turn ON the power after turning it OFF.
Troubleshooting
528
To Next Page
Loading...
