● If the direction of lines in the barcode is perpendicular to the paper output direction, turn the image 90
degrees to make the lines parallel to the paper output direction.
● If the problem persists even after performing the above operation, set [Barcode Adjustment Mode] to
[Narrow].
Setting in the Printer Driver
[Finishing] tab [Advanced Settings] [Barcode Adjustment Mode] [Narrow]
Specifying Settings in the Setting Menu of the Operation Panel
Adjust Barcode(P. 430)
● When [Barcode Adjustment Mode] is set to [Narrow], the overall effect may be such that lines are
printed narrower and the print density is lower than expected.
● When printing from the computer, the setting in the printer driver takes precedence. When the setting
of [Barcode Adjustment Mode] is changed to [Printer Default], the setting in the operation panel takes
precedence.
● If the problem cannot be solved in spite of this item having been set, set <Density: K> to "-1" or "-2."
Density: X (X=C, M, Y, K)(P. 403)
Troubleshooting
555
To Next Page
Loading...
