Problem Cause Solution
ENDLAY - No comms Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
ERROR IN TRIM AREA There is an error at the trim-
mer.
Check the trimmer for a paper
or book jam.
Touch STOP
to clear the
message from the screen.
ERROR - No comms Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
FLOW ERROR - BRIDGE There is an error at the con-
necting bridge. Open the con-
necting bridge cover and
check for a paper jam.
Touch STOP
to clear the
message from the screen.
See
Clear Paper Jams
on
page 85
FLOW ERROR - FORMER There is an error at the former.
Open the folder cover and re-
move the book. If necessary,
open the main deck to remove
the book.
See
Jam in the Folder or For-
mer Area
on page 90
FLOW ERROR - GATHER AREA There is a paper jam in the
gathering area. Open the con-
necting bridge cover, lift the
gathering area and remove
the paper jam.
See
Jam in the Gathering Area
on page 88
FLOW ERROR - OUTFEED There is an error at the out-
feed. Remove the trim bin and
open the trim stop guard to re-
move the book.
If necessary, open the main
deck to remove the book.
See
Jam in the Trim Area
on
page 93
FLOW ERROR - STITCHER There is an error at the stitch-
er. Open the folder cover and
remove the book.
If the problem continues, then
call your service engineer.
See
Jam in the Stitch Area
on
page 89
4
Error Messages
78
Chapter 6 - Error Conditions, Problems and Solutions
To Next Page
Loading...