Problem Cause Solution
Fold blade axis moving The fold blade axis (book
thickness adjustment) is mov-
ing. This message clears when
the adjustment is complete.
If the message does not clear,
touch ADVANCED > RE REF
FOLD BLADE NOT PARKED Open the folder cover, remove
the paper, close the folder
cover. Touch START , then
follow the instructions on the
screen.
FOLD - No comms Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
FORM CLAMP CLOSED The form clamp is in the
wrong position. Touch START
to reset the position. Follow
the instructions on the screen.
FORM ROLLER ERROR Open the folder cover, remove
the paper, close the folder
cover.
See
Jam in the Folder or For-
mer Area
on page 90
FORM ROLLER NOT PARKED The form roller is in the wrong
position. Touch START to
reset the position. Follow the
instructions on the screen.
FORM CLAMP ERROR There is an error at the former.
Open the folder cover and re-
move the book. If necessary,
open the main deck to remove
the book.
See
Jam in the Folder or For-
mer Area
on page 90
GATHERING AREA COVER
OPEN
Close the gathering area cover
if you need to operate the ma-
chine online.
INVERTER ERROR Check for a paper jam and
clear if necessary.
Touch STOP to clear the
message from the screen. If
the problem continues, con-
tact your service engineer.
JAM AT BRIDGE INFEED There is a paper jam at the in-
feed to the connecting bridge.
Clear the jam and continue.
See
Clear Paper Jams
on
page 85
JAM AT FORM ROLLER Open the folder cover, remove
the paper, close the folder
cover.
See
Jam in the Trim Area
on
page 93
4
Error Messages
Chapter 6 - Error Conditions, Problems and Solutions
79
To Next Page
Loading...