Problem Cause Solution
JAM AT STACKER INFEED There is a jam in the stacker
infeed. Remove the books
from the stacker infeed. Press
the reset button on the stack-
er.
See
Jam at Book Stacker in-
feed
on page 104
JAM AT STACKER OUTFEED There is a jam in the stacker
outfeed or there are paper
trimmings in the stacker out-
feed. Remove the books from
the stacker outfeed. Check for
paper trimmings and remove
them if present. Press the re-
set button on the stacker.
See
Jam at Book Stacker out-
feed
on page 105
JAM BEFORE TRIMMER There is a book jammed be-
fore the trimmer. Open the
main deck to remove the
book.
See
Jam before the Trimmer
on page 91
JAM IN CONNECTING BRIDGE There is a paper jam in the
connecting bridge. Clear the
jam and continue.
See
Jam in the Connecting
Bridge
on page 87
JAM IN GATHERING AREA There is a paper jam in the
gathering area. Open the con-
necting bridge cover, lift the
connecting bridge and remove
the paper jam.
See
Jam in the Gathering Area
on page 88
JAM IN STACKER AREA There is a paper jam at the
outfeed of the machine. Re-
move the jammed books and
continue.
JAM IN STITCHER AREA There is a paper jam in the
stitch area. Open the folder
cover, remove the paper jam
and continue.
See
Jam in the Stitch Area
on
page 89
JAM IN STITCH HEAD There is a jam in the stitch
head.
See
Clear a Stitch Head Jam
on page 97
JAM IN TRIMMER There is a book jammed in the
trimmer. Clear the jam and
continue.
See
Jam in the Trim Area
on
page 93
MAIN CONTROL - No comms Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
4
Error Messages
80
Chapter 6 - Error Conditions, Problems and Solutions
To Next Page
Loading...