Problem Cause Solution
MANUALLY PARK SHUTTLE The shuttle is not parked cor-
rectly. Open the folder cover
and move the shuttle to the
park position. Close the folder
cover. The shuttle will reset.
When the message list is
clear, continue operation.
See
Manually park the Shuttle
on page 102
MISSING STITCHES The machine has detected
missed stitches. Check if the
stitch wire is jammed or if the
stitch wire spool is empty.
See
Clear a Stitch-wire Jam
on
page 95
See
Install New Stitch Wire
on
page 123
MOTOR CONTROLLER NOT
READY
The drive motor controller is
not ready. If the problem con-
tinues, contact your service
engineer.
OPERATOR MAINTENANCE The machine needs routine
maintenance by the operator.
See
Operator Maintenance
on
page 110
REBOOT THE MACHINE Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
REMOVE SET FROM FOLD
AREA
Open the folder cover and re-
move the set.
REMOVE SET - GATHERING
AREA
Open the gathering area and
remove the sheets.
REMOVE SET - STITCH AREA Open the folder cover and re-
move the set.
See
Jam in the Stitch Area
on
page 89
Rotate axis moving The rotate axis is moving. This
message clears when the ad-
justment is complete.
If the message does not clear,
touch ADVANCED > RE REF.
ROTATE - No comms Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
4
Error Messages
Chapter 6 - Error Conditions, Problems and Solutions
81
To Next Page
Loading...