Problem Cause Solution
SET IN GATHERING AREA There is a set or partial set in
the gathering area.
Open the gathering area and
remove the sheets.
If the print job has been can-
celed, open the gathering area
and remove the sheets. Or
touch START
, then touch
ADVANCED > PURGE SET >
PURGE SET to clear the set
from the machine.
Shuttle axis moving The shuttle axis is moving.
This message clears when the
adjustment is complete.
If the message does not clear,
touch ADVANCED > RE REF.
SHUTTLE MOTOR COMMS
FAIL
Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
SHUTTLE MOTOR ERROR Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
SHUTTLE - No comms Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
SHUTTLE NOT PARKED The shuttle is in the wrong po-
sition. Touch START , then
follow the instructions on the
screen to reset the position.
Sidelay axis moving The sidelay axis (size adjust-
ment) is adjusting. This mes-
sage clears when the adjust-
ment is complete.
If the message does not clear,
touch ADVANCED > RE REF.
SIDELAY - No comms Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
STACKER FULL The stacker is full. Unload the
books from the stacker.
4
Error Messages
82
Chapter 6 - Error Conditions, Problems and Solutions
To Next Page
Loading...