How to improve black density on the print
Description
On some media the density of black is too low.
Solution
There is a setting available to improve the Black density. It can be adjusted in the “Printer
adjustment” section of the specified media.
Procedure
1.
In your browser open the Settings Editor and go to “Media”
2.
Select the media and then select “Printer adjustment”.
3.
In the “Advanced” section select “Gloss and Fine black adjustment”
4.
Adjust the value to your need. You can change it between -2 and +2. These values are related to
the Gloss-setting. However the Fine-Black setting will also change when you change the Gloss-
Setting. The following relation exists:
Gloss Fine Black
-2 2
-1 1
0 0
+1 0
+2 0
5.
Please take care that this setting can only be used for Plain paper. (So not for coated, vellum etc.)
How to improve black density on the print
Chapter 11 - Appendix 135
PRISMAsync V3.2
To Next Page
Loading...
Need help?
General
