Name: Canon PRISMAsync v3.2
Brand: Canon
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Install the PRISMAsync supports/pedestals

NOTE

To reduce the amount of dust that enters the PRISMAsync controller the supports installed on

the controller have to be replaced with the supplied pedestals.

Replacement of the installed supports

Remove the 4 supports installed on the PRISMAsync controller. The removed supports and

screws will not be used.

2. Install the supports delivered with the PRISMAsync controller (4x M3x16 Hex bolt).

Install the PRISMAsync supports/pedestals

18 Chapter 3 - Installation

PRISMAsync V3.2

Questions and Answers:

Need help?

Do you have a question about the Canon PRISMAsync v3.2 and is the answer not in the manual?

Canon PRISMAsync v3.2 Specifications

General