Canon PRISMAsync v3.2 - Restart the System

Restart the system
You can restart the system via the Settings Editor or via the operator panel. In both cases only the
PRISMAsync will be restarted.
To restart the system via the Settings Editor
1.
Open the Settings Editor (on a PC).
2. Go to [Support] -> [Troubleshooting]
3. Select [Restart the system].
To restart the system via the operator panel
1. Touch [System] -> [Setup] -> [Shut down system].
The operator panel displays the message 'Are you sure you want to shut down?'.
2. Touch [Restart].
NOTE
In some cases the system needs to reboot the engine (max. 2x) to reach the correct start-up
situation.
Restart the system
52 Chapter 5 - Start, shutdown and restart the system
PRISMAsync V3.2