Canon PRISMAsync v3.2 - Reuse USB Stick After Installation

Reuse an USB-stick after installation
Prepare a USB-stick for reuse
It is possible to re-use the USB-stick after an installation. You can check if a USB-stick is ready or
not. A USB stick that is ready for installation is called “OCEINSTALL”. When it is used, the name
is “USEDKEY”. Please take the following steps to re-use the stick for installation of the system
software.
Procedure
1.
Put the USB-stick into a USB port of your computer.
2.
Open the Explorer window.
3.
Check if the name of the USB-stick is "USEDKEY" .
4.
To prepare the USB-stick for reuse open the contents of the stick in your explorer. Double-click
the “ReUseKey.bat” file.
5.
Check (in your explorer screen) if the name of the USB-stick has changed to "OCEINSTALL".
If the name did not change it might be needed that you remove the stick and insert it again.
6.
Your USB-stick is now ready for a new installation.
NOTE
Be aware that the settings you selected at creation of the USB-stick (e.g. "keep existing jobs and
settings after installation") will be used after the stick is prepared for reuse.
Reuse an USB-stick after installation
Chapter 9 - System software 99
PRISMAsync V3.2