Canon PRISMAsync v3.2 - Passwords

Passwords
When servicing the
PRISMAsync or making adjustments you often will need a password for a
specific task. See the list below for an overview of the default passwords, used in the
PRISMAsync.
• Enter Service Mode: 675756
• System Administrator: 71617000
• Key Operator: 13524
• Engine maintenance: 12345
• Remote manager: 12345678
• OMApp (on remote PC): 1836671
Resetting the passwords
It could occur that the password for the System Administrator, Key Operator or Engine
maintenance is lost. In that case a service technician has to reset the password.
NOTE
The Remote Manager password is called Operator password in the Settings Editor.
Do the following steps to reset the passwords:
Procedure
1.
Open the Settings Editor on a remote PC connected to the network of the customer.
(See
The Settings editor on page 58)
2.
Browse to [Configuration]→[Security] and select Reset the system administrator password.
3.
Enter the Service password (675756)
4.
Confirm your choice.
Now the System Administrator password is reset to the factory default. (71617000)
5.
This password can be used to set the new passwords.
Passwords
14 Chapter 3 - Installation
PRISMAsync V3.2