106
[Video Record]
Select whether to record video depending on the event.
If you select [Enable] and an external device input event is triggered, video will be transmitted to the recording destination
specified in [Video Record Action] (P. 96).
[E-mail Notification]
Select whether to send an e-mail notification depending on the event.
If [Enable] is selected, e-mail notification will be performed when an external device input event is triggered.
To use e-mail notification, you must set [Video Record] > [E-mail Notification] (P. 102) beforehand.
[External Device Output for Active Event]
Select whether external device output (1 or 2) is active or inactive when an active event is triggered.
[External Device Output for Inactive Event]
Select whether external device output (1 or 2) is active or inactive when an inactive event is triggered.
[Audio Playback at Active Event]
If you select [Enable], the sound clip specified in [Sound Clip] will play back at active events for the external device input.
[Audio Playback at Inactive Event]
If you select [Enable], the sound clip specified in [Sound Clip] will play back at inactive events for the external device input.
[Sound Clip]
Select the sound clip when [Audio Playback at Active Event] or [Audio Playback at Inactive Event] has been set to
[Enable].
You must register the sound clip with [Video and Audio] > [Audio Settings] (P. 88) beforehand.
[Volume]
Enter the volume for the sound clip.
[Switch Day/Night]
Select the Day/Night Mode switching behavior when an external device input event is triggered.
When [Switch to Day Mode] is set, switches to Day Mode when an active event is triggered, and switches to Night Mode
when an inactive event is triggered.
When [Switch to Night Mode] is set, switches to Night Mode when an active event is triggered, and switches to Day Mode
when an inactive event is triggered.
• When [Day/Night] in the Admin Viewer is set to [Auto] (P. 165), [Switch Day/Night] will not happen when an external device input event
is triggered.
• If the [Switch Day/Night] settings switch Day/Night Mode while the user has camera control privileges, camera control will be released.
To Next Page
Loading...
