Canon VB-M741LE - Page 116

116
Both Events ON
 [Event Linking Method] is Set to [AND], [Event Order] is Specified
This shows examples when [Event Order] is set to [Event 1 -> 2].
When [Event Order] is set to [None], and [Event Linking Method] is set to [AND] linked events will be as in the
examples even if Event 1 and Event 2 are switched.
When Events Occur in Order 1 -> 2
When Events Occur in Order 2-> 1 -> 2
Event 2 Triggered but Event Gap Setting ([4] sec.) Exceeded
ON
Event 1
Event 2
Consolidated
state
OFF
ON
OFF
ON
OFF
ON
Event 1
Event 2
Consolidated
state
OFF
ON
OFF
ON
OFF
ON
Event 1
Event 2
Consolidated
state
OFF
ON
OFF
ON
OFF
Both events are ON, but their order of occurrence is
incorrect. Therefore, a linked event does not occur here.
ON
Event 1
Event 2
Consolidated
state
OFF
ON
OFF
ON
OFF
The gap between the occurrence of event 2 after the
occurrence of event 1 exceeds the value specified for the
[Event Gap] setting. Therefore, a linked event does not occur.
Event gap (4 sec. in this example)