62-11785 5–2
Technician Mode should be canceled when work is complete. If Technician Mode is not
canceled, Technician Mode will be available for 60 minutes after the last key press without
requiring a code, even after placing the SROS in the OFF and then back in the RUN/STOP
position.
4. Once activity requiring use of Technician Mode is complete, Technician Mode should be manually canceled.
• To cancel from the TECHNICIANS MENU screen, highlight CANCEL TECHNICIAN MODE/PIN ACCESS
and then press the “=” key. This will return the system to the Advance User Mode.
• To cancel from any screen, press and then release the two outside soft keys simultaneously (note: the
system will not respond) and then press the “=” key. The system will return to Driver Mode.
5.2.1 Technician Hour Meters
Hour meters, other than the standard hour meters, are available for viewing when in Technician Mode. Instructions
for viewing these hour meters are provided in Figure 5.2.
Figure 5.2 Technician Hour Meters
1. Enter the Technician Mode, as described in Figure 5.2. While in the TECHNICIANS MENU screen, press
the BACK or EXIT key and then press the MENU key until HOUR METERS is displayed.
2. Press the HOUR METER soft key to display the hour meter screen.
START/STOP ELECTRIC COOL
Viewing Menu Soft Key
INTELLISET
PRETRIP
HOUR
METER
UNIT
DATA
Selections
Press Menu Key to Scroll
2
1
HOUR METERS (1 OF 4)
STANDARD HOUR METERS
BACK
EXIT
MAINTENANCE HOUR METERS
OTHER METERS & COUNTERS
RESET HOUR METERS
END OF LIST
NOTE: This line will only
display if one or more hour
meters has timed out and is
ready to be reset.
To Next Page
Loading...
Need help?
General
