62-11785 3–4
3.4 INSPECT MODE
Inspect Mode provides an additional layer of safety for operators and technicians. Inspect Mode should be used
during all pretrip inspections of the unit.
Inspect Mode is a user activated feature that forces the unit to shutdown and remain in shutdown regardless of
operating state.
After unit inspection, Inspect Mode must be manually disabled, at which point the unit will resume standard
operation.
Inspect Mode is not a substitute for proper Lockout/Tagout procedures, which are always required when servicing
the unit.
Enter Inspect Mode:
1. With the system powered up (START/RUN-OFF switch in the START/RUN position) press the MENU key
until INSPECT MODE is displayed.
2. Press the INSPECT MODE soft key, the unit will shut down.
While the unit is in Inspect Mode the ALARM light will flash, and the display will indicate that unit operation,
including temperature control, has been disabled.
Exit Inspect Mode:
3. While the unit is in Inspect Mode, the EXIT soft key will be available, all other keys and functions will be
locked out.
4. Press the EXIT soft key to disable Inspect Mode, the unit will resume standard operation.
START/STOP ELECTRIC COOL
BOX TEMPERATURE
o
F SETPOINT
o
F
INSPECT
MODE
34.3
34
EXIT
1
2
4
NO TEMPERATURE CONTROL
EXIT
OPERATIONS DISABLED
Press EXIT to return to normal
operation
To Next Page
Loading...
Need help?
General
