5–11 62-11785
2. Press the “PC MODE’ soft key. DO NOT remove USB or cable at this time.
3. The MessageCenter will display “PC MODE”. The System is now in PC Mode. The purpose of PC Mode is
to allow demonstration of the System features and allow changes to the System while the unit is not actually
running. It is important to note that any changes saved to memory while in PC Mode will remain after leaving
PC Mode.
Technician Mode should be canceled when work is complete. If Technician Mode is not
canceled, Technician Mode will be available for 60 minutes after the last key press without
requiring a code, even after placing the SROS in the OFF and then back in the RUN/STOP
position.
4. If Technician Mode is entered while in PC Mode, once the Technician Mode activity is complete, re-enter the
Technicians Menu, highlight “CANCEL TECHNICIAN MODE/PIN ACCESS” and then press the “=” key to
take the system out of Technician Mode before taking the System out of PC Mode.
5. When use of PC Mode is completed, remove the USB or cable. “SHUTTING DOWN - PLEASE WAIT” may
be displayed or after a few seconds, the display will go blank. Replace the cover on the USB port.
To Next Page
Loading...
Need help?
General
