A-8. Notes on WindowsDirect
Compatibility Notification Regarding Linking of “WindowsDirect” Function
with Windows®95 Version 4.00.950B
Microsoft Corporation announces that, when a personal computer’s SerialKey Devices are
set up, an OE error may occur, depending on the Windows® 95 version.
Before setting up your personal computer for “Linking with Windows® 95” function of
CAS’s balances, be sure to check your Windows® 95 version and take appropriate
precautionary measures according to this instruction, whenever required.
1 This information is provided only for the benefit of Shimadzu customers.
It is the responsibility of the customers to take these precautionary measures on their
own. Shimadzu Corporation as well as Microsoft Corporation does not have any
responsibility for anything caused by the precautionary measures here.
2 If you have attempted to setup SerialKey Devices without taking these precautionary
measures and Windows® 95 will not start normally, follow the procedure below:
x Restart your personal computer.
x While “Starting Windows® 95...” is being displayed on the screen, press
[F8] key and then select “3 Safe mode” to start up the system.
x Select [Control Panel] > [Accessibility Options] > [General] and remove
the check mark on the [Support SerialKey devices] check box.
x Restart Windows®95.
1. Confirmation of the Windows®95 Version
x Click [Start] > [Settings] > [Control Panel].
x Double-click [System].
x Read the [General] tab's system information.
If it is:
Microsoft Windows® 95
4.00.950B
go to “2. Precautionary Measures.”
If not, perform setup according to the instruction manual of your balance without taking
precautionary measures written here.
To Next Page
Loading...
Need help?
General
