4.4 Turning ON the Power
1. Insert the plug of the AC adapter into the
DC IN connector on the rear of the
balance.
2. Insert the AC adapter into the power
source. The balance self-check is activated
and the following messages are displayed
in the order indicated.
[HELLo], [CHE 5], [CHE 4], [CHE 3],
[CHE2], [CHE1], [CHE0], whole lighting,
[oFF] ([CHE 5] and [CHE 4] are not
displayed for the UX series).
A power cable may be necessary to connect the AC adapter to the power
source, depending on the type of the AC adapter.
3. Press [POWER] key. The whole display
illuminates and then the display changes to
indicate the gram-display. The backlight is
illuminated.
When using the optional battery pack (special accessory), connect the fully
charged battery pack to the DC IN connector of the balance using the cable
attached to the battery pack.
To Next Page
Loading...
Need help?
General
