79
14.4 Interval Timer
Automatically outputs the displayed value at preset intervals. The “T” symbol (“T” of the
Tare symbol) is illuminated when the Interval Timer is activated.
The optional AKB-301 Application Keyboard is convenient when the interval is changed
frequently.
1. Select menu item 50 and set the output interval
(00:01 = 1 sec to 99:59 = 99 minutes 59 seconds).
2. In the interval timer standby state when the “T”
and the Stand-by symbols are both illuminated,
press the [PRINT] key.
The first data is output. Data will be automatically
output at the set time intervals thereafter.
3. To stop output, press the [POWER] key.
The balance returns to the interval timer standby
state in step 1).
x Use the [O/T] key to erase the tare or zero the balance at any time.
x Pressing the [POWER] key in the interval timer standby state brings the power
supply standby state.
x Interval Timer setting can be cleared without menu operation, by pressing the
[POWER] key for about three seconds. This does not clear the set time interval value.
x Using the interval timer function to record data over a long period may cause data
error due to balance drift.
x Some instruments receiving the data may not operate normally if the set time interval
is short. To correct this, set the time interval to a longer period. When the set time
interval is short and the instrument connected to DATA I/O is unknown, it is
recommended to set the handshake to a setting other than “H-tm” 76 .
x Not more than one of these seven functions can be set at a time. Setting the second
one with the menu will automatically clear the previously set function;
Auto Print(13.3), Auto Zero(13.4), Peak Hold(14.3), Interval Timer(14.4), Add-on
mode(14.5), Animal Weighing mode(14.6), Formulation mode(14.7).
To Next Page
Loading...
Need help?
General
