80
14.5 Add-on Mode
This function is convenient for weighing a large number of sample components as they are
added on the balance. Every time a component is added and stability is detected, the mass of
it is displayed and output through RS-232C or DATA I/O interface. The display will then be
automatically zeroed for the next component. When all the components have been weighed,
the total mass is calculated by pressing [POWER] key.
Select menu item 52 .
1. Load the weighing vessel and press the [O/T] key in
the Add-on standby state (The “Add-on” and
the Standby symbols are lit).
Zeroing occurs.
2. Press the [PRINT] key.
The Stand-by symbol disappears, and Add-on
measurement starts.
3. Load the first sample.
When stability is detected with a displayed value
five times the Zero Range or more, the displayed
value is automatically output and zeroing occurs.
Even if the displayed value is less than five times
the Zero Range, pressing [PRINT] key at stability
causes the same effect.
4. Repeat the above step 3 until all the components
have been weighed.
5. Press the [POWER] key.
The total sample mass on the pan is displayed and
the balance returns to the Add-on standby state.
Press the [PRINT] key to output the total mass.
Start the next set of measurements from the above
step 1.
To Next Page
Loading...
Need help?
General
