46
9. Display Selection
9.1 Bar graph display
The relative amount of the load on the pan is displayed in the bar graph. This feature helps
to prevent errors due to OL (overload) status. This is called Full Scale mode. This display
can not be used with the Checkweighing or Target mode.
Select the menu item 11 to set up Full Scale mode.
(Example) (1) (2)
A bar displayed in the lower areas of the scale indicates
that the load on the pan is small. (1) A bar displayed up
to the upper areas of the scale indicates that the load on
the pan is close to the weighing capacity. (2).
To display no bar graph, select menu item 21 .
9.2 Changing the Minimum Display Digit (10d:1d)
It is possible to decrease the resolution of the minimum balance display by one decimal
place if necessary.
1. Press and hold the [UNIT] key for approximately
three seconds. “- 10d -” is displayed and
the display is decreased by one decimal place.
2. Press and hold the [UNIT] key for approximately
three seconds. “- 1d -” is displayed and the
display returns to the original number of decimal
places.
The location of the decimal point in the display does not shift. In the “10d” display,
the last digit is empty.
To Next Page
Loading...
Need help?
General
