Case 570T - Starting the engine - At low temperatures

246 pages

To Next Page

To Previous Page

4-OPERATINGINSTRUCTIONS

Startingtheengine-Atlowtemperatures

Whenstartingacoldengineattemperaturesbelow5°C

(41°F),openthethrottlefully.Turnthekeyto“ON”until

theenginestarts,thenreleasethekey.Iftheenginefails

tostart,waitforoneminuteandrepeatthestartingproce-

dure.

4-7

Main Page

Foreword9
Note to the Owner10
Intended Use11
Electro-Magnetic Compatibility (EMC)13
Product Identification14
Component Identification18
Safety Rules19
Ecology and the Environment26
Hand Signals27
Backhoe Buckets32
Safety Signs34
Access to Operator's Platform43
Operator's Seat46
Front Controls47
Pedal Controls49
Transmission Controls51
Right Hand Side Controls54
Instrument Cluster - Front56
Instrument Cluster Panel – Side57
Instrument Cluster58
Heating, Ventilation, Air Conditioning (HVAC) Controls60
Cab and Platform - Control Identification61
Loader Attachment Controls63
Loader Attachment – Operation64
Booms, Dippers, and Buckets - Control Identification69
Left-Hand Stabilizer Left-Hand Control Lever72
Right-Hand Stabilizer Right-Hand Control Lever73
Slider Frame Control Pedal74
Commissioning the Machine75
Operating the Machine76
Road Operation77
Job Site Operation78
Starting the Engine79
Assisted Starting (Jump-Starting)80
Starting the Engine - at Low Temperatures81
Stopping the Engine82
Moving the Unit83
Parking the Unit86
Requirements for Road Travel87
Precautions for Road Travel88
Preparing the Machine for Road Travel89
Setting the Backhoe Attachment in Road Travel Position92
Locking or Unlocking the Backhoe Attachment94
Machine Transport (on a Trailer)95
Towing the Machine96
Operating the Machine in Cold Weather99
Operating the Machine in High Altitude100
Operating the Machine in High Temperatures101
Operating the Machine in Water102
Lifting the Machine103
Organizing the Job Site104
Transmission Disconnect Button105
Operating the Loader Attachment106
Loader Attachment Safety Strut109
Loader Bucket – Removal110
Loader Bucket – Install111
Backhoe Attachment112
Setting the Backhoe Attachment in Working Position113
Operating the Backhoe Attachment114
Filling the Backhoe Bucket115
Moving the Machine Forwards When Working116
Trenching117
Backhoe Bucket Remove119
Backhoe Bucket Install120
Backhoe Bucket – Digging Angle121
Fluids and Lubricants123
Fuel124
Fuel Storage125
Fuel Tank126
Hydraulic Oil127
Hydraulic Oil Tank128
Engine Oil Viscosity129
Safety Instructions130
Machine Safety131
Work Hours and Intervals132
Maintenance Chart133
Parking Brake134
Fuses and Lamps135
Functionality of Controls and Lamps137
Drive Belts - Check138
Engine Oil Level - Check139
Transmission Oil Level - Check140
Engine Coolant Level - Check141
Hydraulic Oil Level - Check142
Fuel Tank Level - Check – Level143
Restriction Indicator– Check144
Grease Points – Lubricate145
Engine Oil and Oil Filter – Change147
Fan / Alternator Belt Tension149
Battery Electrolyte Level - Check150
Wheels Re-Torque151
Hydraulic System Breather - Clean152
Battery Check153
Front Axle Breather (4WD Only) - Clean154
Water Separator Drain155
Rear Axle Differential Oil - Check156
Engine and Cabin Mounting Bolts Re-Torque157
Front Axle Hub Oil Level (4WD Only) – Check158
Stabilizer Wear Pads Adjust159
Engine Oil and Oil Filter – Change161
Mud Filter - Change163
Fuel Filter - Change164
Powershuttle Transmission – Oil Change165
Transmission Oil Filter - Replace166
Transmission Suction Strainer - Cleaning167
Hydraulic Oil Filter - Replace168
Front Axle Hub Oil (4WD Only) - Replace169
Rear Axle Hub Oil - Replace170
Front Axle Differential Oil (4WD Only) - Replace171
Rear Axle Differential Oil - Replace172
Front Axle - Hub Greasing 2WD173
Check the Fuel Injector175
Hydraulic Oil - Replace176
Engine Coolant - Replace177
Radiator and Oil Cooler Fin - Cleaning179
Engine Air Filter180
Tires Pressure - Check182
Radiator - Cleaning184
Condenser - Cleaning185
Pollen Filter - Cleaning186
Storing the Machine187
Short Term Storage188
Storing the Engine189
Battery Storage190
Taking the Machine Back to Service191
Removal from Storage192
Engine - Troubleshooting193
Starter Motor - Troubleshooting195
Alternator - Troubleshooting196
Transmission - Troubleshooting197
Axles - Troubleshooting199
Steering System - Troubleshooting202
Hydraulic Systems - Troubleshooting203
Loader Attachment - Troubleshooting204
Backhoe Attachment - Troubleshooting205
Swing - Troubleshooting206
Hydraulic Pump - Troubleshooting207
Electrical Systems - Troubleshooting208
Heating, Ventilation, Air Conditioning (HVAC) - Troubleshooting209
Specifications211
Material Weights – Material220
Torque Chart – Metric Non-Flanged Hardware221
Torque Chart – Metric Flanged Hardware222
Identification223
Torque Chart – Inch Non-Flanged Hardware224
Torque Chart – Inch Flanged Hardware225
Identification226
Units of Measure and Conversion227

Case 570T - Starting the engine - At low temperatures

Table of Contents

Other manuals for Case 570T

Related product manuals