CG emotron TSA Series - Stored Values [730]; Real Time Clock Settings [740]

134 Functionality CG Drives & Automation, 01-5980-01r2
8.7.3 Stored Values [730]
The shown values are the actual values built up over time.
Values are stored at power down and updated again at power
up.
Run Time [731]
This menu displays the total time that the softstarter has been
in the run mode.
Reset Run Time [7311]
This menu resets the run time counter. The stored
information will be erased and a new registration period will
start.
Mains time [732]
This menu displays the total time that the softstarter has been
connected to the mains supply. This timer cannot be reset.
Energy [733]
This menu displays the total energy consumption since the
last energy reset [7331] took place.
Reset Energy [7331]
This menu resets the energy counter. The stored information
will be erased and a new registration period will start.
8.7.4 Real time clock settings [740]
This menu group displays actual time and date. The menus
are quickly accessed from the default toggle loop. See Fig. 32,
page 46.
Time and date are factory set to CET (Central European
mean time). Adjust if required in following Submenus.
Time [741]
Actual time, displayed as HH:MM:SS. Adjustable setting.
Date [742]
Actual date, displayed as YYYY-MM-DD. Adjustable setting.
Weekday [743]
Display of actual weekday.
Read-only
Unit: h: mm:ss (hours: minutes: seconds)
Range: 00: 00: 00–262143: 59: 59
Default: No
No 0
Yes 1
NOTE: After reset the setting automatically reverts to
“No”.
Read-only
Unit: hh: mm:ss (hours: minutes: seconds)
Range: 00: 00: 00–262143: 59: 59
Read-only
Unit: Wh (shows Wh, kWh, MWh or GWh)
Range: 0 Wh–999,999 GWh
731 Run Time
Stp h:mm:ss
7311 Reset RunTm
Stp No
732 Mains Time
Stp hh:mm:ss
733 Energy
Stp kWh
Default: No
Selection: No, Yes
Unit: hh:mm:ss (hours: minutes: seconds)
Unit: YYYY-MM-DD (year-month-day)
Read-only
7331 Rst Energy
Stp No
741 Time
Stp 00:00:00
742 Date
Stp 2014-01-28
743 Weekday
Stp Monday