48 Operation via the control panel CG Drives & Automation, 01-5980-01r2
6.6.1 The main menu
This section gives you a short description of the functions in
the main menu. For a more detailed description of the
contents under each main menu, see chapter 8. page 67.
100 Preferred View
Displayed at power-up, this menu shows two actual process
data (electrical power and current as default). The menu is
programmable for many other read-outs.
200 Main Setup
Here you find the main settings to get the softstarter
operable, such as motor data, protection and
communication settings.
300 Process
This menu contains settings more relevant to the
application, such as start and stop settings using analogue
Process value.
400 Process Protection
To protect the machine and process from damage, a number
of protection settings, such as the load monitor, can be
configured under this menu.
500 I/Os and Virtual Connections
Settings for inputs and outputs are entered here.
600 Logical Functions and Timers
A set of freely programmable blocks are available in this
section.
700 View Operation and Status
In this menu you can view operational data (power, torque,
current, etc.), and get status information about e.g. clock,
date, inputs and outputs.
800 View Trip Log
Here you can see the last 9 trips in the trip memory.
900 System Data
This menu contains information on softstarter model and
software version.
To Next Page
Loading...
Need help?
General
