Ciena 6200 - Page 101

To Next Page

To Previous Page

6-1

6200 Packet-Optical Platform Installation, Commissioning, and Testing Procedures

Release 1.1 009-6200-201 Draft Issue 1

2014 Ciena

Corporation September 2014

Nodal commissioning 6-

This chapter provides the commissioning procedures you must perform on a

newly installed network element. Nodal commissioning is performed using the

web user interface by entering the commissioning data of the network

element.

Procedure list

Table 6-1 lists the procedure to prepare a network element for commissioning.

Table 6-2 lists the procedures in sequence, to commission a network element.

Table 6-1

Preparing a network element for commissioning

Action Details

Connecting the PC to the local craft terminal of the

6200 network element

Procedure 6-1

Note: The commissioning data record form is used to record the commissioning

data for a network element. Refer to Chapter 12, Recording data and test results.

Table 6-2

Commissioning procedures

Step Action Details

1 Connecting the PC to the local craft terminal of the

6200 network element

Procedure 6-1

2 Logging into an uncommissioned 6200 network

element

Procedure 6-2

3 Network element initialization Procedure 6-3

4 Verifying the serial numbers of the 6200 chassis

and the circuit packs

Procedure 6-4

5 Setting the 6200 date and time Procedure 6-5