7-56 System testing
6200 Packet-Optical Platform Installation, Commissioning, and Testing Procedures
Release 1.1 009-6200-201 Draft Issue 1
Copyright
©
2014 Ciena
®
Corporation September 2014
Procedure 7-12 (continued)
Testing Ethernet parameter retrieval using SNMP
Step Action
10 Getting the current 15 minutes counter value for a particular attribute for a
particular Ethernet port:
a. Set the OID in the iReasoning MIB browser to be the following;
.1.3.6.1.4.1.8255.1.2.1.2.37.1.1.(OID).(Rate).(Chassis).(Slot).(Port).
The value which is retrieved from the SNMP query would be the same as
the one which is seen in the UI for that particular parameter. There would
be no discrepancy between the value and the actual rate shown on the
NE UI.
b. On executing the operation Get from the browser, the browser should
return the value of the counter which corresponds to the OID which is
mentioned in step a.
11 Getting the previous 15 minutes interval counter values for a particular
attribute for a particular Ethernet port:
a. Set the OID in the iReasoning MIB browser to be the following:
.1.3.6.1.4.1.8255.1.2.1.2.37.2.1.(OID).(Rate).(Chassis).(Slot).(Port).(Int
erval Number) The value which is retrieved from the SNMP query would
be the same as the one which is seen in the UI for that particular
parameter. There would be no discrepancy between the value and the
actual rate shown on the NE UI.
b. On executing this operation with the correct interval number starting from
1, the network element would return the historical counter value for the
OID which is mentioned in step a.
12 Getting the previous day interval counter values for a particular attribute for a
particular Ethernet port:
a. Set the OID in the iReasoning MIB browser to be the following;
.1.3.6.1.4.1.8255. 1.2.1.2.37.3.1.(OID).(Rate).(Chassis).(Slot).(Port).1
b. On executing the get operation in the iReasoning browser, the network
element would return the previous day counter for that attribute which is
mentioned in the OID.
—end—
To Next Page
Loading...