8-2 Network reconfiguration
6200 Packet-Optical Platform Installation, Commissioning, and Testing Procedures
Release 1.1 009-6200-201 Draft Issue 1
Copyright
©
2014 Ciena
®
Corporation September 2014
Procedure list
Table 8-1 lists the procedures that are described in this chapter
Table 8-1
Network reconfiguration procedures
Action Details
Adding an 6200 network element to a STM-1/OC-3 ring
configuration with 15G MRO XC circuit pack
Procedure 8-1
Adding an 6200 network element to a STM-4/OC-12 ring
configuration with 15G MRO XC circuit pack
Procedure 8-2
Adding an 6200 network element to a STM-16/OC-48 ring
configuration with 15G MRO XC circuit pack
Procedure 8-3
Adding an 6200 network element to a STM-64/OC-192 ring
configuration with 60G MRO XC circuit pack
Procedure 8-4
Deleting an 6200 network element from a STM-1/OC-3 ring
Configuration with 15G MRO XC circuit pack
Procedure 8-5
Deleting an 6200 network element from a STM-4/OC-12
ring Configuration with 15G MRO XC circuit pack
Procedure 8-6
Deleting an 6200 network element from a STM-16/OC-48
ring Configuration with 15G MRO XC circuit pack
Procedure 8-7
Deleting an 6200 network element from a STM-64/OC-192
ring Configuration with 60G MRO XC circuit pack
Procedure 8-8
Adding a 6200 node into a MS-SPRing/BLSR configuration Procedure 8-9
Deleting an 6200 node from a MS-SPRing/BLSR
configuration
Procedure 8-10
To Next Page
Loading...