CIM MDT500 HE - Declarations of Compliance

MDT500 HE - Operator's Manual
14
1.14 DECLARATIONS OF COMPLIANCE
The manufacturer MF Group S.p.A. - CIM division - Via Serra, 2 - 40012 Calderara di Reno - Bologna –
Italy, declares under its sole responsibility that the embosser MDT500 HE is compliant with the main
international standards and particularly that:
MDT500 HE complies with part 15 of
FCC rules, subchapters A and B -
sections 15.107 (b) (e) and 15.109 (b)
(g) - concerning Class A digital
devices.
The device complies with the provisions contained in part 15
of the FCC rules. Its functioning depends on the following
two conditions:
(1) This device cannot cause damaging interferences, and
(2) This device must allow prospective interferences,
including those that might cause undesired operation.
UL60950 Approval (Safety of
Information Technology Equipments)
File No. E231519
The equipment complies with the
following European Directives:
2004/108/EC, 2006/42/EC, 2006/95/EC.
MDT500 HE complies with the IEC
International Standards on Safety of
Information Technology Equipment, EN
60950-1:2006 and IEC 60950-1:2005
(modified)
Certificate N. NO50313/A1 dated 2008-12-
12
CB