MDT500 HE - Operator's Manual
4.6.2. CARD TEST
This option allows to perform some embossing tests that enable the
specialized technical staff to check the proper functioning of the embosser.
This option is only for the specialized technical staff or for authorized people.
4.6.3. OPERATIONAL MODE
This option allows to set some operating modes during the stages of the tag
embossing process.
There are three working modes: CONTINUOUS, PAUSE, WITHOUT TAG
and all their combinations.
This option is usually only for specialized technical staff or for authorized
people.
4.6.4. SYSTEM INFORMATION
The option provides technical information about the embosser, such as the
level and the version of the CPU boards present in the machine and their
firmware as well as the memory state.
To Next Page
Loading...