MDT500 HE - Operator's Manual
4.5.7. SAVE CONFIGURATION (LOCAL)
It allows to store in the memory of the machine all its parameters and
settings.
This allows to restore the embosser to its original or previous condition in
case the parameters or settings have been accidentally modified or even
lost.
From the “SETUP” menu you can access the Save config local function by
pressing key
8
or by moving with the keys
k
or
i
until you reach the
function and then press
b
.
To return to “SETUP” press key
s
.
1- Refer to the previous point 2 to enter into the menu.
2- When
b
has been pressed MDT500 HE automatically saves all its
parameters and settings in its memory.
On the display, an hourglass will indicate the saving in progress.
The operation might require a few minutes.
WARNING:
whenever saving, the previously saved file is overwritten.
To Next Page