MDT500 HE - Operator's Manual
Now the machine is ready to operate both in STAND ALONE mode and in ON-LINE mode
connected to a computer.
If a BLADE application software is used, the system is already able to produce metal plates either
through a serial connection or USB.
But if another application software is employed, it is necessary to check the correct configuration
of the parameters concerning the communication protocol
To access those parameters refer to the chapter “USE AND SETTINGS OF THE MACHINE”.
Refer to the chapter “USE AND SETTINGS OF THE MACHINE” also to operate in STAND
ALONE mode.
If the machine does not start, make sure that the supply voltage is correct and check the integrity of
the fuse.
If the machine does not complete the cycle described above, then malfunctions might be occurring.
In this case see the chapter Error messages and problem solving.
CHECKING THE FUNCTIONALITY OF SAFETY DEVICES
In order to guarantee the functioning of the machine in safety conditions it is necessary that the
interlock switches of the panels work properly.
Before starting the work shift (at least once a day) switch the machine on and when it is in
READY condition, open the front cover. Then check that the machine, after any interput, signals
an alert situation "cover open or pin in its seat". Close the cover and press RETURN; the machine
will run a reset cycle to go back to the READY condition.
If the machine does not do as described above, this means that the safety devices are not
operating correctly. In this case, switch the machine off and contact the technical service.
CAUTION:
IF THE DISPLAY LIGHTS UP BUT NOTHING
APPEARS ON THE SCREEN, SWITCH THE
EMBOSSER OFF AND CALL THE TECHNICAL
SERVICE
IMPORTANT:
IF YOU HEAR UNUSUAL NOISES OR SOUNDS
COMING FROM THE MACHINE, SWITCH IT
OFF IMMEDIATELY AND CALL THE
TECHNICAL SERVICE
To Next Page