MDT500 HE - Operator's Manual
4.6.6. TEST
This option allows to perform some tests on several components of the
embosser helping the specialized technical staff to verify their proper
functioning.
This option is only for the specialized technical staff or for authorized people
and it is protected by password in some of its parts.
4.6.7. SAVE CONFIGURATION IN USB
This option allows to save on a USB FLASH PEN DRIVE all the parameters
and settings of the embosser. Whenever saving, the previous file, if present,
is overwritten.
The saved file allows to restore the embosser to its original or previous
condition, in case the parameters or settings have been accidentally
modified or even lost.
This option is only for the specialized technical staff or for authorized people.
4.6.8. UPDATE SOFTWARE CPU1
This option allows to update the firmware and the setup file of one of the
CPU boards installed on the machine (CPU1).
This option is only for the specialized technical staff or for authorized people
and it is protected by password.
The careless use of this option might cause the deletion or the partial loss of
the machine program and consequently the machine would be out of order.
4.6.9. UPDATE SOFTWARECPU2
This option allows to update the firmware of one of the CPU boards installed
on the machine (CPU2).
This option is only for the specialized technical staff or for authorized people
and it is protected by password.
The careless use of this option might cause the deletion or the partial loss of
the machine program and consequently the machine would be out of order.
4.6.10. DISABLE COVER
This option allows to inhibit the control of the switch that detects the opening
of the front panel, by disabling the safety device that stops the operation of
the mechanical parts of the machine and letting it emboss.
This option is meant only for the specialized technical staff or for authorized
people and it is protected by password.
To Next Page
Loading...