MDT500 HE - Operator's Manual
5.3 END OF THE PRODUCTION CYCLE
The cycle ends with the ejecting of the card into the front
tray of the embosser as indicated in the picture.
MDT500 HE ends its job and goes to the starting state
READY.
If errors occurred during the cycle, the machine shows on
the display the error code and asks if you prefer to repeat
the tag or continue. During the AUTOMATIC JOB
PRODUCTION the machine continues repeating the wrong
tag independently and signaling the error in the file obtained
with the “SAVE PRINTED CARDS” function.
The different error situations are described in the chapter:
Error messages and problem solving.
IMPORTANT:
The coordinates of the fields must take into
consideration the tag formats managed by the machine
To Next Page