MDT500 HE - Operator's Manual
Format Format being used.
It indicates the number and name of the format being used, that is the
preset active format.
01 OPEN
format name
format number
Error Error condition, machine blocked.
It shows the code and message of the error that caused the machine halt.
The notice appears only when an error condition occurs.
The machine does not work and waits for a command.
E Alarm signal.
It draws the operator's attention by flashing continuously until the error
condition is removed.
The signal is always associated to an error code and message generated by
the embosser.
E Tag presence detector control disabled.
The embosser embosses even without the tag.
When this function is active do not enter tags into the loading.
E Continuous mode enabled.
The embosser continuously repeats the last task launched.
E Pause mode enabled.
If you repeatedly press key
b the embosser performs step by step each
single process of tag customization.
E Machine partial counter.
It displays the number of tags produced from the moment it was enabled.
The counter is not connected to any format or job.
It can be enabled/disabled and reset at any time by the user.
To Next Page
Loading...