Cisco 300 Series Administration Guide

IP Configuration
Domain Name
320 Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
17
- Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—If the IPv6 address type is Link Local, select the
interface through which it is received.
• Host Name—Enter a user-defined host name or fully-qualified name. Host
names are restricted to the ASCII letters A through Z (case-insensitive), the
digits 0 through 9, the underscore and the hyphen. A period (.) is used to
separate labels.
• IP Address(es)—Enter a single address or up to eight associated IP
addresses (IPv4 or IPv6).
You can select the Clear Table option to clear some or all of the entries in the Host
Mapping Table.
• Static Only—Deletes the static hosts.
• Dynamic Only—Deletes the dynamic hosts.
• All Dynamic & Static—Deletes the static and dynamic hosts.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48