Cisco 300 Series Administration Guide

Quality of Service
QoS Advanced Mode
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version) 512
25
STEP 3 Enter the parameters.
• Aggregate Policer Name—Enter the name of the Aggregate Policer.
• Ingress Committed Information Rate (CIR)—Enter the maximum
bandwidth allowed in bits per second. See the description of this in the
Bandwidth page.
• Ingress Committed Burst Size (CBS)—Enter the maximum burst size (even
if it goes beyond the CIR) in bytes. See the description of this in the
Bandwidth page.
• Exceed Action—Select the action to be performed on incoming packets
that exceed the CIR. Possible values are:
- Forward—Packets exceeding the defined CIR value are forwarded.
- Drop—Packets exceeding the defined CIR value are dropped.
- Out of Profile DSCP—The DSCP values of packets exceeding the
defined CIR value are remapped to a value based on the Out Of Profile
DSCP Mapping Table.
STEP 4 Click Apply. The Running Configuration file is updated.
Configuring a Policy
The Policy Table Map page displays the list of advanced QoS polices defined in
the system. The page also allows you to create and delete polices. Only those
policies that are bound to an interface are active (see Policy Binding page).
Each policy consists of:
• One or more class maps of ACLs which define the traffic flows in the policy.
• One or more aggregates that applies the QoS to the traffic flows in the
policy.
After a policy has been added, class maps can be added by using the Policy Table
page.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48