Cisco 300 Series Administration Guide

24
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version) 474
Access Control
The Access Control List (ACL) feature is part of the security mechanism. ACL
definitions serve as one of the mechanisms to define traffic flows that are given a
specific Quality of Service (QoS). For more information see Quality of Service.
ACLs enable network managers to define patterns (filter and actions) for ingress
traffic. Packets, entering the device on a port or LAG with an active ACL, are either
admitted or denied entry.
This section contains the following topics:
• Access Control Lists
• Defining MAC-based ACLs
• IPv4-based ACLs
• IPv6-Based ACLs
• Defining ACL Binding
Access Control Lists
An Access Control List (ACL) is an ordered list of classification filters and actions.
Each single classification rule, together with its action, is called an Access Control
Element (ACE).
Each ACE is made up of filters that distinguish traffic groups and associated
actions. A single ACL may contain one or more ACEs, which are matched against
the contents of incoming frames. Either a DENY or PERMIT action is applied to
frames whose contents match the filter.
The device supports a maximum of 512 ACLs, and a maximum of 512 ACEs.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48