Cisco CATALYST 2960 - Effects of Removing a Provisioned Switch from a Stack; If you remove a provisioned switch from the switch stack, the configuration associated with the removed stack member remains in the running configuration as provisioned information. To completely remove the configuration, use the no switch stack-member-number provision global configuration command.; Stack Software Compatibility Recommendations; All stack members must run the same Cisco IOS software version to ensure compatibility in the stack protocol version among the members.

2-165
Catalyst 2960 Switch Command Reference
OL-8604-03
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
lacp port-priority
Examples This example shows how to configure the LACP port priority on a port:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# lacp port-priority 1000
You can verify your settings by entering the show lacp [channel-group-number] internal privileged
EXEC command.
Related Commands Command Description
channel-group Assigns an Ethernet port to an EtherChannel group.
lacp system-priority Configures the LACP system priority.
show lacp [channel-group-number]
internal
Displays internal information for all channel groups or for
the specified channel group.